hours 3500 + -
If you keep the gear long enough these will go.
Problem was reverse started to decline over time to a point where it was getting a bit annoying.
The reverse rides of the forward pedal via a small bearing. AM10726 and the rest of the assembly has 4 more bearings AM 123565.
Nice little machine
removing reels make the job go faster.
Then remove this bracket.
These bolts will drop out opening in frame.
On reassembling tighten this bolt up last , the hole is slotted for na better fit.
Remove both pedals.
When assembling center pedal in opening before tightening.
Traction linkage remove next.
Bent needle nose pliers helps get those rue clips off.
Remove the bearing plate shaft holder bolts.
Might need a helper wrench to crack them loose.
More Rue clips on end of shafts.
You can see a notch out area ( left front in pick) so it can drop forward on that side to slide it all out.
Install the new bearings.
Don't hammer what looks like a sleeve to get bearing out ,It's part of the casting.
This style chisel work ok to remove them.
A few pics of old bearings
New reversing bearing.
Also save these washers for assembling.
Wasn't nmuch left to old one.
The other unit was pretty much gone.
Another pic of casting lip.
A helper wrench to snug them up good .
A few more pics above.
reasemble in reverse order .
Feel and work like new.
Had to adjust the park brake on one of them .
No comments:
Post a Comment