Noticed one of the rear roller brush was knock out of whack . It pretty much chewed the half bristles off .
Remove the j hooks from both ends of shaft .
Belt cover and belt next .Then the 3 bolts holding the plate on .
Take the brush adjustment bolts out on the drive side and pull it out of the other end as one piece .
Ready to pull out .
Pull the rubber seal off the end and slide the old one off , if it doesn't move just whined it off .
New brush .
I lined it up with the old marks and slide it on the shaft . Went on fairly easy .
Put the J bolts back on and make sure the end goes in the other hole . Tighten up snug on both ends .
Reassemble in reverse order .
All done . Love these brush kits .....so easy to work on .
No comments:
Post a Comment